[Introduction 2] The first 5 Gunpla tools

1. Nipper — Scissors to cut parts from the runner. Single-edged nippers leave less white marks (whitening).

2. Design knife — Thinly shave off the remaining gate marks. Cut in the opposite direction of your hand.

3. Sandpaper/sponge sandpaper — Arrange the marks in the following order: 400 → 600 → 1000.

4. Ink pen — Draw on the panel lines to create a three-dimensional effect. The easiest operation compared to the most effectiveness.

5. Matte top coat — When you spray it at the end, the toy-like shine disappears and the ink lines and sticker boundaries are cleaned up.

At first, just nippers and an ink pen are sufficient. ‘Complete to the end’ comes before equipment!